Civil Contractors: Who Certifies the Cable You Lay?
Short answer for civil contractors: you can dig the trench, lay the duct and pull the cable. What you cannot do, unless you hold the registration, is terminate, test and certify it — that is prescribed electrical work. Knowing exactly where that line sits stops your job stalling at the last step.
We are electricians with a skilled digger operator on the crew, so we do our own trenching on our own jobs. But plenty of runs are bigger than our gear, and on those we would rather work alongside a civil contractor than pretend otherwise.
Where the handover sits
Comfortably yours
Trench route, depth and profile.
Locating and protecting existing services.
Duct and conduit installation, draw wires, bedding and backfill.
Reinstatement and surfacing.
Pulling cable through duct, where that is agreed in scope.
Needs a registered electrician
Cable selection and sizing. Sized for the distance as well as the load — a long run needs more than the current alone suggests.
Terminations at both ends.
Protection and isolation at the board.
Testing, and the Certificate of Compliance. Mains-level work also needs a Record of Inspection.
Anything connecting to the point of supply, which also brings the lines company in.
The full customer-facing version of this split is in trenching contractor or electrician.
Three things that cause rework
Duct sized before the cable was. If the electrical design lands after the duct is in and the cable will not fit or cannot be sized down, the trench opens again. Twenty minutes of conversation up front avoids it.
Depth and mechanical protection set for the wrong cable type. Requirements differ, and they change again under vehicle crossings.
No marker tape and no as-built. The next contractor on that site will find the cable with a bucket if nobody recorded where it went.
How we work with civil crews
Scope conversation before the dig, so cable size, duct size and depth are agreed rather than assumed.
We turn up when the trench is open, not three days later. An open trench is a hazard and a weather risk and we treat it that way.
Clear split on the quote, so the client can see which part is yours and which is ours.
We certify our own work and hand the paperwork over with the as-built detail you need.
Where we cover
Waikato and South Auckland from Waerenga — Te Kauwhata, Huntly, Ngāruawāhia, Hamilton, Morrinsville, Paeroa, Thames, Cambridge, Te Awamutu, and north to Pokeno, Tuakau, Pukekohe, Papakura and Manukau.
Questions contractors ask
Can you just come and terminate what we have already laid?
Yes, provided the cable is right for the job. If it was sized without an electrical design we will tell you before we connect it rather than after.
Do you do drainage work too?
No. We are not registered drainlayers. Our digging capability is for electrical runs — wastewater and stormwater drainage is not work we take on.
Will you compete with us on civil jobs?
Not on the ones that need your gear. We trench our own domestic and light commercial runs. A long civil run, a bore under a road or a major reinstatement is your work, not ours.
Do you carry the right cover?
Yes. Registered since 2013, EWRB E 243698, and we will send our documentation before we come on site.
Set up a referral arrangement
If you regularly lay cable that somebody else has to certify, having one electrician who answers the phone and turns up is worth more than a list of three. Call Kris on 021 466 666, or see the underground services page.
Comments