top of page

WiFi Heater Install in Cambridge — Redwood, Rinnai, Goldair and the Multi-Room Spec

Kris Goff
Jun 18
1 min read

WiFi Heater Install in Cambridge — Redwood, Rinnai, Goldair and the Multi-Room Spec

Call Kris on 021 466 666

Cambridge homes tend to be bigger than the Waikato average, and the heating spec follows — heat pumps as primary, WiFi panel heaters in every secondary room.

What a WiFi heater install actually involves

  • Plug-in (under 2kW) — simple.

  • New socket + plug-in — for cases where the existing socket isn't in the right spot.

  • Permanently wired — for higher-wattage units, bathrooms, dedicated switching.

What's specific to Cambridge WiFi heater installs

  • Multi-heater installs dominate. A typical Cambridge job is 5-8 heaters across the house in a single visit.

  • Carters Flat, St Kilda, Howell Avenue subdivisions — modern switchboards, heat-pump-as-primary.

  • Heritage and inner-Cambridge — older switchboards sometimes need work first.

  • Lifestyle blocks toward Karāpiro, Hautapu, Maungatautari — heater installs in detached secondary dwellings.

  • Equestrian properties — bathroom or grooming-area heaters in stable blocks (wet-zone considerations).

  • Smart-home integration — heaters tied into Clipsal Wiser or Loxone systems.

Brand options

Redwood WIFI V2, Rinnai (top of spec list, paired with Rinnai hot water), Devola, Bromic (outdoor patio), Goldair.

What it costs

Multi-heater install across 5-8 rooms one visit $1,500-$2,500. Single heater $200-$700. Permanent wired with new circuit $500-$900 per unit. Sleepout or stable-block with longer cable run $700-$1,200.

Call Kris on 021 466 666

Photos of each room plus heater brand and wattage.

Recent Posts

See All

Comments


bottom of page